SEAL 62C - Page 6

6 User Manual 62C/62S
5Operating 20
5.1 Process controls 20
5.1.1 Control panel 20
5.1.2 Heater control (MR62S only) 22
Additional controls 23
5.1.4 Error indications 24
5.2 Operating modes 27
5.2.1 Normal mode 27
5.2.2 Slow mode 28
5.3 Placing film rolls 29
5.3.1 Auto-grip shafts 29
5.3.2 Use of films with release liner 29
5.3.3 Loading shaft with film rolls 30
5.3.4 Use of a splitter bar 31
5.3.5 Presetting the tension 31
5.3.6 Pressure setting 32
5.4 Webbing 33
5.4.1 Upper section only 33
5.4.2 Upper and lower section 34
5.4.3 Result to Roll or Roll to roll 35
5.5 Processes and settings 36
5.5.1 Mounting images or decals 36
5.5.2 Pre-coating panels 37
5.5.3 Over-lamination 37
5.5.4 Single-sided lamination 37
5.5.5 Double-sided lamination 38
5.5.6 Decaling 38
5.6 Unloading 38
6 Maintenance 39
6.1 Cleaning 39
6.1.1 Cleaning the silicone covered rollers. 39
6.2 Preventive maintenance 40
6.2.1 Auto-grip shafts 40
6.3 Trouble shooting 40
6.4 Technical assistance 42
7 Glossary 43