AG3000 INSTRUCTIONS
Seametrics • 253.872.0284 Page 3 seametrics.com
GENERAL INFORMATION
The AG3000 Series is a spool-type electromagnetic
owmeter for use in irrigation applications in 3” to 12” pipe.
With no moving parts, these meters provide unobstructed
ow and are resistant to wear from debris found in ground
or surface water. Little maintenance is required because
there are no bearings to wear out or propellers to stop
turning. Minimal straight pipe requirements allow AG3000
meters to be used in piping congurations where there is
little space between the meter and an elbow.
The standard AG3000 is battery powered with an available
pulse output. Both rate and total indication show on
the meter mounted display. Bidirectional ow reading is
standard with totals available in forward, reverse, net ow,
batch forward ow, and batch reverse ow. Batch totals
can be reset. Built-in data logging is available as an option
Features
AG3000
Flanges, 150 lb. ANSI pattern
Equalization lug
Powder-coated diecast
aluminum electronics
housing
Rate and total indicator with light sensor
button controls
316SS electrodes (Inside)
Power and Output cable
port access
Hinged cover
No moving parts
Unobstructed Flow
Data logger port (right
side, not shown)
for secure ow logging.
The AG3000 is also available with external DC power. With
an externally powered AG3000 an additional output can
be added, such as 4-20mA, HART, Modbus
®
, or high speed
digital.
The AG3000 Series is CE certied and IP68 for burial, or
applications where the meter may be under water for
prolonged periods of time. All meters are provided with
a security seal to protect against unauthorized access.
The seal can be broken by an authorized agent to replace
the battery pack or eld install a power/output cable. The
cable is eld installed where external power is available
and/or an output is needed.
Santoprene/Polypropylene Liner
(Noryl
®
Liner, 3” only)
Welded steel epoxy-
coated ow tube
(Ductile cast iron ow
tube, 3” only)
User access lid