Seat ATECA 2024 - Page 44

42
Safety
WARNING
●
If seat belts are worn incorrectly or not at
all, the risk of severe injuries increases. The
optimal protection from seat belts can be
achieved only if you use them properly.
●
Never allow two passengers (even chil-
dren) to share the same seat belt.
●
Never unbuckle a seat belt while the vehi-
cle is in motion. Risk of fatal injury.
●
The seat belt should never lie on hard or
fragile objects (such as glasses or pens, etc.)
because this can cause injuries.
●
Do not allow the seat belt to be damaged
or jammed, or to rub on any sharp edges.
●
Never wear the seat belt under the arm or
in any other incorrect position.
●
Bulky and unfastened clothing (such as an
overcoat over a sweater) impairs the proper
fit and function of the seat belts, reducing
their ability to protect.
●
The slot in the seat belt buckle must not be
blocked with paper or other objects, as this
can prevent the latch plate from engaging
securely.
●
Never use seat belt clips, fastening rings or
similar items to alter the position of the belt
webbing.
●
Frayed or torn seat belts or damage to
the connections, belt retractors or parts of
the buckle could cause severe injuries in the
event of an accident. Therefore, you must
check the condition of all seat belts at regu-
lar intervals.
●
Seat belts which have been worn in an ac-
cident and have been stretched must be re-
placed by a specialised workshop. Renewal
may be necessary even if there is no ap-
parent damage. The belt anchorage should
also be checked.
●
Do not attempt to repair a damaged seat
belt yourself. The seat belts must not be re-
moved or modified in any way.
●
The belts must be kept clean, otherwise
the retractors may not work properly.
Seat belt buckled indication
Lights up red
The driver or passenger has not fastened
the seat belt.
The control lamp lights up to remind the
driver to fasten their seat belt.
Before starting the vehicle:
●
Fasten your seat belt securely.
●
Instruct your passengers to fasten their seat
belts properly before driving o.
●
Protect children by using a child seat ac-
cording to the child's height and weight
›››page55.
When starting to drive, if the vehicle's speed
exceeds approx. 25km/h (15mph) and the seat
belts are not fastened or are unfastened while
driving, a warning sound will be heard for a few
seconds. In addition, the warning lamp on the
instrument cluster display flashes.
The lamp goes out when the driver and pas-
senger seat belts are fastened with the ignition
switched on.
Rear seat belts fastened display
Fig.17 Instrument cluster: indication of the
status of the rear seat seat belts.
Depending on the version of the model, when
the ignition is switched on, the status display of
the belts ›››Fig.17 informs the driver on the in-
strument panel display whether the occupants
of the rear seats have their seat belts fastened.
Indicates that the corresponding seat is
empty.
Indicates that the seat is occupied and the
occupant is wearing the seat belt.