Seat ATECA 2024 - Page 62

60
Safety
●
Size class: The indication of class according to size corresponds to the authorised body weight for the child seat. In child seats with universal or
semi-universal approval, the class according to size is indicated on the ECE approval label. The indication of class according to size is stated on the
corresponding child seat.
●
IUF: Suitable for forward-facing ISOFIX / i-Size “universal” child restraint systems approved for use in this weight group.
●
IL: It is suitable for certain ISOFIX child restraint systems that can be for the specific vehicle, restricted or semi-universal categories. Take the child
seat manufacturer's vehicle list into account.
●
IB: Seat suitable for installing an ISOFIX forward-facing group 2/3 booster seat as well as an i-size forward-facing child seat for children with a height
of 100 to 150cm.
●
X: Position not suitable for ISOFIX or i-Size child restraint systems in this weight group or size class.
Securing the child seat with the ISOFIX or
i-Size system
Fig.36 Rear seat: location of the ISOFIX or
i-Size securing rings.
Fig.37 Rear seats: fitting a child seat with the
ISOFIX system.
You must follow the child seat manufacturer's
instructions.
The location of the ISOFIX or i-Size anchor
points is indicated by a symbol ›››Fig.36. In
some vehicles, the rings are secured to the seat
frame and, in others, they are secured to the
rear floor.
●
Press the child seat onto the ISOFIX or iSize
securing rings until it is heard to engage se-
curely ›››Fig.37. If the child seat is equipped
with Top Tether anchor points, secure it to the
correspondent ring ›››page61. Follow the
child seat manufacturer’s instructions.
●
Pull on both sides of the child seat to ensure
that it is properly anchored.
Child seats with the ISOFIX or i-Size and Top
Tether attachment system can be purchased
from technical services.