Seca 644 - Servicing

Servicing • 111
English
10.SERVICING
The product must be set up carefully and serviced
regularly. Depending on how frequently the product is
used, we recommended servicing at intervals of 3 to 5
years.
NOTICE!
Incorrect measurements as a result of poor
servicing
► Have servicing and repairs carried out
exclusively by seca Service or by an
authorized service partner.
► You can find service partners in your area at
www.seca.com or by sending an e-mail to
service@seca.com.
The display "Er:[No.]:11"
appears.
The scale has too high a load or too high a load in
one corner.
-Take the load off the scale or distribute the
weight more evenly
-Restart the scale
The display "Er:[No.]:12"
appears.
The scale has been switched on with too high a
load.
-Remove the load from the scale
-Restart the scale
The display "Er:[No.]:16"
appears.
The scale was caused to oscillate, the zero point
could not be determined.
-Restart the scale
The Enter key
(send/print) is pressed
and the display
"Er:[No.]:71" appears.
No data transmission possible, wireless module
deactivated.
-Activate wireless module (see "Activating the
wireless module (SYS)" on page 103)
The Enter key
(send/print) is pressed
and the display
"Er:[No.]:72" appears.
No data transmission possible, no wireless group
set up.
-Set up wireless group (see "Setting up a wire-
less group (Lrn)" on page 103)
Problem Cause / Solution