MMX
TM
User Guide
21
2. Bypass Menu
Use the Bypass Menu when you want to bypass or unbypass devices, hardware circuits, complete addressable
loops, or outputs such as relays and signals.
To enter the Bypass Menu, you must be in the Command Menu. To enter the Command Menu, press
when the display is in normal mode.
The following subsections provide instructions on using each Bypass Menu option.
Step 3: Select Node
• Select a Node by using and to scroll
through the numbers, then when the correct
Node number appears.
Step 4: Pwr Src Report
The battery voltage will be displayed as per this
example.
Step 1: Select the Bypass Menu
1. Use and to scroll the cursor to “Bypass”.
2. Press to select the Bypass Menu.
Step 2: Enter your passcode (if required)
Enter your passcode. See page 10 for instructions on
entering passcodes.
Step 3: Select the option you would like to view
1. Use and to scroll the cursor through the
Bypass Menu.
2. Press to select an option.
Press to exit and return to the Bypass Menu.
Repeat to exit to the Command Menu.
Battery Voltage
Node 02
Battery: 27.75V
- Command Menu -
1 Reports
2 Bypass
3 Walktest
^
Enter passcode for
level 1 or higher:
- Bypass Menu -
1 Device /Circuit
2 Relay disc
3 Input Zone
To Next Page
Loading...
Need help?
General
