MMX
TM
User Guide
39
10. Choose Configuration
Select this option if you would like to select the configuration version to upload into the system.
The MMX
TM
display will show the following while in Choose Config mode:
At this point the display will vary, depending on your choice:
• If you select “no”, the display shows the message “Operation Cancelled”, then it will return to the Command
Menu.
• If you select “yes”, the system begins the upload of the configuration and the display shows:
Step 1: Select Choose Configuration
1. Use and to scroll the cursor to “Choose
Config”.
2. Press to continue.
Step 2: Enter your passcode (if required)
Enter your passcode. See page 10 for instructions on
entering passcodes.
Step 3: Select the Configuration version to Upload
• Use and to select the which version of
configuration (up to 3 versions) you wish to upload.
• Press to download the version.
Step 5: Select “yes” or “no”
• Use and to select “yes” or “no”.
• Press to continue.
- Command Menu -
8 Network Restart
9 Config Info
10 Choose Config
Enter passcode for
level 2 or higher:
- Config Info -
V1: Job Name
V2: Job Name Rev 1
V3: Job Name Rev 2
Are you sure you
want to change the
system
configuration? Y
System
Configuration
in process ...
To Next Page
Loading...
Need help?
General
