Why does my Secutron Fire Alarm show 'Unconfigured CPU Trouble'?
The 'Unconfigured CPU Trouble' message on Secutron Fire Alarms appears when annunciators or loop adders connected to the panel are either not programmed in the Configurator or are configured with an incorrect address.
What to do if my Secutron Fire Alarm displays 'I/O Adder Mismatch Trouble'?
The 'I/O Adder Mismatch Trouble' message on Secutron Fire Alarms shows when the hardwired adder modules are in the wrong order, the wrong quantity, or not connected. Ensure the number of physical hardwired adder modules matches the configuration and that they are properly connected.
Why am I getting a 'Display Mismatch Trouble' on my Secutron Fire Alarm?
The 'Display Mismatch Trouble' message on Secutron Fire Alarms indicates that the number and order of display modules (RAX-1048/TZ, FDX-008, and IPS-2424) connected to the panel do not match the configuration. Verify that the display modules are connected correctly.
What does 'Unconfigured Device Trouble' mean on my Secutron Fire Alarm?
The 'Unconfigured Device Trouble' message on Secutron Fire Alarms appears when an analog device is physically installed but is not included in the configuration program.
How to fix 'Printer Data Loss Trouble' on a Secutron Fire Alarm?
The 'Printer Data Loss Trouble' message on Secutron Fire Alarms indicates that a printer is configured but not physically connected to the panel when a message is sent to it. Clear this trouble by pressing the System Reset button.
What causes 'Slave (RAXN-LCDs) Configuration Version Mismatch Trouble' on Secutron Fire Alarms?
The 'Slave (RAXN-LCDs) Configuration Version Mismatch Trouble' message on Secutron Fire Alarms means that the firmware versions on all the CPUs are not compatible.
Why does my Secutron Fire Alarm show 'Slave (RAXN-LCDs) Configuration Address Mismatch Trouble'?
The 'Slave (RAXN-LCDs) Configuration Address Mismatch Trouble' message on Secutron Fire Alarms appears when the addresses of the configured slaves do not match.
What does 'Slave Configuration Type Mismatch' mean for Secutron Fire Alarms?
The 'Slave Configuration Type Mismatch' message on Secutron Fire Alarms indicates that the physical loop adder does not match the loop adder type specified in the configuration program. For example, this will appear if the physical adder module is an ALC-396, but the configuration program specifies an ALC-H16.
Why is my Secutron Fire Alarm displaying 'Wrong Device Type'?
The 'Wrong Device Type' message on Secutron Fire Alarms shows if the type of analog device does not match the type listed in the configuration program. For example, this message appears if an ionization sensor is connected at address 013, but the configuration program lists address 013 as a photoelectric sensor (or vice versa).
What causes the 'Multiple Unconfigured Device Trouble' on Secutron Fire Alarms?
The 'Multiple Unconfigured Device Trouble' message on Secutron Fire Alarms indicates that there are two identical (duplicate) devices at the same address on the same loop.
General| Brand | Secutron |
|---|---|
| Model | MMX-2009-12NDS |
| Category | Control Panel |
| Language | English |
To Next Page
