What to do if Secutron Control Panel shows Battery Trouble?
If your Secutron Control Panel indicates a Battery Trouble, it's likely due to low voltage (below 20.4 V). The suggested solution is to replace the batteries as soon as possible.
What to do if Secutron Control Panel shows Ground Fault?
If your Secutron Control Panel is showing a Ground Fault, inspect for any external wiring that might be touching the chassis or any other earth ground connection.
How to fix Circuit Trouble on Secutron Control Panel?
To address a Circuit Trouble issue on your Secutron Control Panel, check for open wiring on the affected circuit, and ensure the circuit is not disconnected or bypassed.
What to do if Secutron MR-2300 reports Remote Fail?
If your Secutron Control Panel reports a Remote Fail, check for any failure reported by, or failure to communicate with a remote annunciator or other remote device.
How to fix ground fault on Secutron MR-2300 Control Panel?
To address a ground fault in your Secutron Control Panel, check for any external wiring that might be touching the chassis or any other Earth Ground connection.
What to do if Secutron MR-2300 shows common trouble?
If your Secutron Control Panel displays a common trouble, inspect for any missing interconnection wiring. Also, verify that no modules are missing from the original configuration and ensure all cabling is securely connected.
How to troubleshoot circuit trouble on Secutron MR-2300 Control Panel?
To troubleshoot a circuit trouble on your Secutron Control Panel, check for any open wiring on the affected circuit loop. Also, ensure that the circuit hasn't been disconnected or bypassed, as disconnecting a circuit will cause a system trouble.
General| NAC Outputs | 2 |
|---|---|
| Output Voltage | 24 VDC |
| Input Voltage | 120 VAC, 60 Hz |
| Operating Temperature | 32°F to 120°F (0°C to 49°C) |
| Dimensions | 14.5 in H x 12.5 in W |
| Weight | 5.4 kg (12 lbs) |
To Next Page
