MMX
TM
User Guide
25
3. Walk Test Menu
Use the Walk Test Menu when you want to test the devices in a system. Performing a walk test will place the
system in trouble (non-latching).
To enter the Walk Test Menu, you must be in the Command Menu. To enter the Command Menu, press
when the display is in normal mode.
The subsections following provide instructions on using each One Man Walk Test Menu option, Audible Test and
Silent Test.
Note: Walk test records that are viewed on the screen will be stored in the event log.
Step 1: Select the Walk Test Menu
1. Use and to scroll the cursor to “Walktest”.
2. Press to select the Walk Test Menu.
Step 2: Enter your passcode (if required)
Enter your passcode. See page 10 for instructions on
entering passcodes.
Step 3: Select the option you would like to view
1. Use and to scroll the cursor through the
menu.
2. Press to select an option.
Press to exit and return to the Command Menu.
Step 4: Select the One Man to see this next menu
1. Use and to scroll the cursor through the
menu.
2. Press to select an option.
Press to exit and return to the Command Menu.
- Command Menu -
1 Reports
2 Bypass
3 Walktest
Enter passcode for
level 1 or higher:
- Walktest -
1 One Man
2 Walktest report
- Walktest -
1 Audible Test
2 Silent Test
To Next Page
Loading...
Need help?
General
