ASSEMBLY AND INSTALLATION
29
6
4
Take out 1 urea (plastic head) screw and re-
move the DVD DRIVE case lid.
5
Press the DVD DRIVE switch and the DVD
DRIVE tray will come out. Set the DVD from
the DVD software kit into the tray. Always
have the labeled side facing upward.
FIG. 6-13a
FIG. 6-13b
6
Press the DVD DRIVE switch. The tray goes back into the drive.
7
Re-engage the power. Turn the main switch to OFF once, wait for at least one minute, then turn the switch
back to ON.
8
Software is installed automatically from the DVD to the LINDBERGH. In some cases, it may take about 5
minutes to install software to the LINDBERGH.
9
Initialization is completed when the Attract Mode screen appears.
10
Press the DVD DRIVE switch so that the tray comes out. Remove the DVD.
11
Press the DVD DRIVE switch so that the tray goes back into the unit. If the power is cut off, the tray will
not move.
12
Set the main switch to OFF.
13
Remove the DVD wire from the DVD DRIVE.
CASE LID
To Next Page
Loading...
Need help?
General
