Sega OutRun - Mechanism Unit Removal

17.
REMOVING
THE
MECHANISM
UNIT
The
mechanism
unit
can
be
removed
as
follows:
CAUTION:
To
avoid
any
danger
when
removing
the
mechanism
unit,
do not
enter
the
cabinet
or
lean
against
it.
REMOVING
THE
MECHANISM
4
M10
BOLTS
(D
Remove the
V BELT
(see
REPLACING THE BELT).
(
2
)
Remove the
limit switch connector.
® Release the shoulder screw
of
the rod end.
(Be sure
only to release
the screw and do
not
take
it
off.)
(?)
Take
off the 4 nuts
and
4
bolts shown above.
(D
Take off
the
rod end shoulder screw
and
move the cabinet
to
the left. (When the shoulder screw
is
removed,
the
cabinet
becomes free.
Pay
particular attention
so as not
to
allow
unauthorized persons access
to it.)
The mechanism unit
can be
removed
by
following the above
procedure
as
described in(T)~(5):
-
18
-