Sega Showdown - Coin Handling Fault Finding

COIN HANDLING
75
12
12-2 FAULT FINDING
Fault Finding
The following information is presented for customers’ guidance in rectifying a fault but does not cover all possible
causes.
All acceptors with electronic faults should be returned to an approved service centre for repair.
SYMPTOM INVESTIGATE POSSIBLECAUSE
Acceptordoesnotwork
(allcoinsreject)
Connector
PoorContact
LooseWire
PowerSupply
Notswitchedon
Incorrectvoltage
Inadequatecurrent
Risetimetooslow
Inhibitallinputs AcceptorInhibited
Acceptgate Gatenotfreeordislocated
Acceptchannel Obstruction
Rejectgate Notfullyclosed
LEDonrearcoverRED
EEPROMchksmerror
SRSensorfault
Creditoptofault
Creditsensorblocked
Rejectleverpressed
LEDonrearcoverYELLOW Reinstallpower
PoorAcceptance
PowerSupply Voltagelessthan10v
(Voltagedropswhencoil
engages)
Acceptgate Gatejamordislocated
Connector Loose
Coinrundown Dirty
BankSelect Bothbanksenabled
Coinstickorjamin
acceptor.
Acceptchannel
Acceptordirtyormayhave
somedamage
Acceptgate
Rejectgate
Atruecointyperejects Label Coinnotprogrammed
Noacceptsignal
Connector Looseorbrokenwire
Acceptchannel Pathdirtyorobstructed
To Purchase This Item, Please Visit : BMIGaming.com | Call Global Sales : + 561.391.7200 | USA / CA : (800) 746-2255