*The alarm voltage of the remote control is adaptive to 2S, 3S, 4S
lithium batteries and 4 NI-MH batteries. That is, if T8FB is powered
by 2S, 3S, 4S lithium batteries or 4 NI-HM batteries, after connecting
the battery, T8FB will automatically set the low voltage alarm value
according to the battery type.
1.3.2 Receiver pairing
Each transmitter has an independent ID code. Before starting to
use the device, receiver must pair the code with the transmitter. After
pairing the code, the ID code is stored in the receiver, and there is no
need to pair it again, unless the receiver is used with another
transmitter. When you have a new receiver, you must pair the code
again, otherwise the receiver will not work normally.
（ 1 ） Place the remote control and receiver horizontally with a
spacing of about 50cm；
（2）Turn on the power switch of the remote control to supply
power to the receiver, and the receiver’s LED light starts to flash
slowly；
（3）Press the pairing code button （ID SET）on the side of the
receiver for more than 1 second, the LED light starts to flash quickly,
that means the code is being paired, and the receiver will look for the
To Next Page
Loading...