Segway RMP Lite 220 - Component Descriptions

8
1.2 Component description
Table 1
No.
Component name
Description
1
Power button
On：Hold down, when power button and indicator light are
always on and accompanied by a beep, chassis boots
successfully. At this time, the chassis is in lock mode, and the
indicator light is steady yellow.
Off：Hold down until the prompt sound starts，release the
button，chassis shut down successfully. At this time, power
button and indicator light are always off.
2
Indicator light
Colors and status of the indicator light represent different
modes of the product.
3
Driving wheel
11 inch high adhesion pneumatic tire with good shock
absorption and design with drainage tank.
4
Universal wheel
Super Artificial rubber, lightweight and shock absorption.
5
Mounting hole
Use to install upper equipment.
6
Battery
Power supply to chassis and upper system.
7
Emergency stop
button
Use to switch the chassis to emergency stop mode in an
emergency.
8
Charging port
Connect the charger to charge the device.
9
Battery lock
Used to fix the battery, need to use the matching key to open.
10
Upper computer
power supply port
It supplies power to the upper computer, with a maximum
current of 10A.
11
Electric control box
Use to install circuit module to control the chassis.
12
Upper computer
power supply port
It supplies power to the upper computer.