nearest remote control to pair the code;
（4）When the receiver’s LED light stops flashing, it means that
pairing the code is completed. If the receiver ’ s LED light flashes
slowly, it means that pairing the code has failed, the code needs to
be paired again.
1.3.3 Remote control control car instructions
（1）Turn on the RMP chassis: press the RMP power button;
Note: Please check the RMP status. Press and hold until the
buzzer sounds and there is no continuous beeping, the indicator light
is steady yellow.
（2）Turn on the remote control: push up the power switch of the
remote control;
Note: ensure that the remote control is not in the emergency stop
state and enters the enable state.That is, the emergency stop switch
is not at the bottom, and the enable switch is dialed from the top to
the bottom.
（3）At this time RMP is in Normal mode , see the table below for
specific operations:
To Next Page
Loading...