Sekonic L-608 - Page 38

-34-
1. To enter the custom setting mode, the meter must first be turned off. Set DIP switch 4 to on
position and turn the power on. It is not possible to enter the custom setting mode if DIP switch
4 is set to on after turning on the power.
2. In the custom setting mode, 'CS' (custom setting) is
displayed in the ISO display area, a setting number
between 01-11 (608) or 01-12 (608 CINE) is
displayed in the shutter speed display area and item
number 0, 1, 2 or 3 is displayed in the aperture
display area.
3. Turn the Jog wheel t and select the desired setting
number and the custom setting name.
4. The item number will change each time the Mode set button !0 is pressed.
*1 1/10 stop fractions are displayed in below combinations ( )
T priority
F priority
F1 stop
F1/3 stop
F 1/2 stop
T 1/3 stop
–
–
T 1/2 stop
–
–
T 1 stop
–
–
F1 stop
F1/3 stop
F 1/2 stop
T 1/3 stop
–
–
–
T 1/2 stop
–
–
–
T 1 stop
*2 Individual: LUX, FC, cd/m
2
or FL
Compound: LUX+T+F, FC+T+F, cd/m
2
+T+F or FL+T+F (combination)
Custom setting no.
Custom setting
item
6. Advanced Functions