-37-
CAUTION
• When using quad channels 17-32, it is not possible to terminate this mode unless a sub-
channel has been set (a, b, c or d is displayed).
6. Advanced Functions
3. The set channel number will blink on and off at this time.
Turn the Jog wheel to set the channel setting.
4. In the Setting mode, "ch" appears on the ISO display area. At the same time, channel numbers
(1 to 16 and 17 to 32) appear on the F display area. When the channel number is 17 to 32, sub-
channel (A, b, c and d) settings are displayed on the T indicator. In the absence of settings, "-
" appears in the figures.
5. In sub-channel settings, after the channel is set to 17 to 32, the mode button is pressed. Following
this, the 4th figure on the T display area blinks to indicate that settings may be made. Every
time the mode button is pressed, the blinking settings shifts from sub-channel No. : 4th figure →
3rd figure → 2nd figure → 1st figure → channel No., while permitting settings for each sub-
channel. As the Jog wheel is rotated in this state, setting ("A, b, c and d" displayed) and
resetting ("-" displayed) alternate. During this process, the indicator continues to blink to indicate
the channel being set.
→
Set by manipulating the mode set button.
↔ Set by manipulating the Jog wheel.
To Next Page
Loading...
