Sekonic Litemaster Pro L-478DR - Setting Radio Flash Mode in Custom Setting

5
1-3. Setting Radio Flash Mode in Custom Setting
Make sure “6) Flash Mode” is switched ON and “c) Radio Mode” is switched ON, and
select “c-i) Radio System Preference”, either Standard and/or ControlTL.
1) Press the Menu button on the meter to open the Menu screen.
2) Touch [3. Custom Setting] and select [c-i) Radio System
Preference] under [6. Flash Mode] in the displayed Menu screen.
3) Touch the radio button to select which system you want to use.
Menu screen Custom Setting screen Radio System Preference screen
4) Touch [OK] to complete the setting and return to the Custom Setting screen. (Touch
[Cancel] to return to the Custom Setting screen without change.)
5) Press the Menu button at the Custom Setting screen to return to the top of Menu
screen. Press the Menu button again to return to the Measuring screen.
6) In the Radio Flash mode, the Measuring screen shows the setting of Standard and/or
ControlTL indication along with channel number and zones selected.
Standard System, Channel (1 to 16)
Standard System, Channel (17 to 32)
and Zones
ControlTL System, Channel and Zones
• 
Setboththemeterandplug-inexternalorbuilt-inPocketWizardreceiverstothesamesystem(Standardand/orControlTL).
Menu button
Measuring screen
(Radio Triggering screen)