Sekonic Litemaster Pro L-478DR - Measuring; Selecting the Channel and Zones; How to set in Standard System

6
2 Measuring
2-1. Selecting the Channel and Zones
2-1-1. How to set in Standard System
1) Touch the Tool Box icon ( ) at the bottom right of the Measuring screen to display
the Tool Box screen.
2) Touch the [Radio CH/Zone] to display the Radio CH/Zone Setting screen.
3) Touch the STD tab for Standard Channel and Zones selection.
4) Touch the arrows ▲/▼ or slide your nger over the screen to select Channel from
1 to 32. When the channel number from 17 to 32 is selected, Zones (A, B, C, D)
appear.
5) Touch one or more Zones (A, B, C, D) to select the ash units you want to use.
* Zones to use can be selected from Power Control Screen as well.
6) Touch [OK] to conrm settings and return to the Measuring screen. (Touch [Cancel]
to go back to the Measuring screen without change.)
Radio CH/Zone Setting screen
(When Standard Channel is selected)
Measuring screen
Tool Box screen
Channel numbers
STD tab
Zones
•
Setboththemeterandplug-inexternalorbuilt-inPocketWizardreceiverstothesameStandardsystem.
•
ThelastselectedZonesineitherPowerControlscreenorRadioCH/ZoneSettingscreeninToolBoxareactivatedin
Measuringscreen.