Sekonic Litemaster Pro L-478DR - How to set in ControlTL System

7
2-1-2. How to set in ControlTL System
1) Touch the Tool Box icon ( ) at the bottom of the bottom right of the Measuring
screen to display the Tool Box screen. Then touch [Radio CH/Zone] to display the
Radio CH/Zone Setting screen.
2) Touch the [Radio CH/Zone] to display the Radio CH/Zone Setting screen.
3) Touch the CTL tab for ControlTL Channel and Zones selection.
4) Touch the arrows ▲/▼ or slide your nger over the screen to select Channel from 1
to 20 for FCC & IC, or from 1 to 3 for CE version.
5) Touch one or more Zones (A, B, C) to select the ash units you want to use.
* Zones to use can be selected from Power Control screen as well.
6) Touch [OK] to conrm settings and then return to the Measuring screen. (Touch
[Cancel] to cancel settings to go back to the Measuring screen without change).
Radio CH/Zone Setting screen
(When ControlTL system is selected)
Measuring screen
Tool Box screen
Channel numbers
CTL tab
Zones
•
Setboththemeterandplug-inexternalorbuilt-inPocketWizardreceiverstothesameControlTLsystem.
•
ThelastselectedZonesineitherPowerControlscreenorRadioCH/ZoneSettingscreeninToolBoxareactivatedin
Measuringscreen.