U.2.30
SEL-421/SEL-421-1 Relay User’s Guide Date Code 20020501
Installation
Front-Panel Labels
Step 9. When the labels print correctly on the test sheets, print the
labels on the perforated stock sheets.
If the labels are incorrect, repeat this procedure beginning with
Step 4 on page 2.29.
Step 10. Fold and tear the perforated edges of the stock paper to remove
the labels from the sheet.
Step 11. Use the Label Removal Tool to remove existing labels from
front-panel label pockets and insert the created labels in the
appropriate pockets on the relay front panel. (Figure 2.18 on
page 2.26 shows the Label Removal Tool.)
Step 12. To change the labeling again, remove existing labels and repeat
the above procedure.
To Next Page
Loading...
