ENGLISH - 9
a.
b.
c.
3. Back to HOME position & Turning o
After use and before travelling, press HOME to return the unit back to HOME position.
To fully turn off the unit, press and hold POWER for 5 seconds when the unit is at HOME position.
If user stays in a location for an extended period or wish to save power user can leave the unit up by
simply turning off the unit by ROUTER button on the left side of controller. ROUTER PW LED will be off
but signal stills comes through.
FINE TUNE mode can be initialized when a selected satellite is found and user wants to increase the signal
strength further.
a.
b.
c.
d.
4. Special function 1 : FINE TUNE mode
Press TUNE to start FINE TUNE mode.
First TUNE is for AZ (Azimuth). Adjust antenna position using arrow buttons to find a new position
providing better signal quality and press OK to set. The signal level will be displayed on the controller
(Q ___ ) or satellite receiver.
Repeat the same process of adjust the EL (Elevation) and SK (LNB skew).
To save new position of the satellite and exit, press TUNE button. Saved new position will be placed
in the memory for the next turn on. But once vehicle moves or confirms new GPS location, the saved
position will be reset.
Error message LED will be illuminated and the error message detail will be shown on LCD display, this will
detail if there is a problem with main unit.
i.
5. Special function 2 : ERROR MESSAGE
HOME POSITION error
If antenna does not come back to HOME position within the allowed time or the system does not
recognise HOME position despite the antenna being back at HOME position (The Limit sensor is
faulty).
ii. TUNNER error
If there is no response when searching the satellite due to a faulty tuner or its settings.
iii. MOVEMENT error
If the PRO MAX cannot move to correct position for some reason.
iv. COMMUNICATION error
If connection is lost between the unit and controller that lasts longer than 5 seconds.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
