SELFSAT SNIPE AIR User Manual

ENGLISH - 12
5. Advanced Settings
To select and set numbers, use arrow buttons to see available options. The numbers adjust individually with the
cursor and press OK to move to next option. This function is only used if the satellite operator changes all its
parameters.
NOTE
Modify Transponder (TP) mode
i. Press MODE twice to enter “Modify TP mode” and press OK.
ii.
iii.
iv.
v.
vi.
vii.
viii.
ix.
Select the satellite to be modified, as example “00 XXXX(satellite name) ~ 11 XXXX” and press OK..
Select TP number among “00~02” and press OK. (Three TP’s are programmed for each satellite)
Repeat the same process by inputting data for NID (Network identity), FREQ (frequency) and
SYMBOL (symbol rate).
Select type of signal DVBS or DVBS2 and press OK.
Select polarization VER (vertical) or HOR (horizontal) and press OK.
Select YES or NO to save and/or go back to first stage of TP Modify.
To exit, press MODE and the unit will return to previous status.
For manual TP data RESET, press MODE to enter TEST mode and press OK. Go to “TP RESET” and
press OK among available functions on LCD using arrow buttons.
Restart the unit to apply the reset to next start up.

SELFSAT SNIPE AIR Specifications

General

Gain	33.7 dBi
Polarization	Horizontal/Vertical polarization
Elevation angle range	-15 - 90 °
Input frequency range	10.7 - 12.75 GHz
Output frequency range	950 - 2150 MHz
Product color	White
Operating temperature (T-T)	-20 - 60 °C
Quantity	1

Weight and Dimensions

Depth	192 mm
Width	515 mm
Height	355 mm
Weight	10900 g