On New Concrete
• Ensure that at least 40” of wire extends out of the conduit.
• Insert the anchor plate into the concrete immediately after pouring the concrete.
• It is recommended to vibrate the concrete to eliminate any air bubbles.
• Anchor plate surface should be in level with the ground.
On Existing Concrete
• Ensure that at least 40” of wire extends out of the conduit.
• Mark anchoring points with the help of anchor plate template.
• Drill 4 holes into the concrete, each minimum 2.2” deep.
• Put anchor bolts provided by SemaConnect, ensuring that bolts extend out.
• Place anchor plate on top of stud anchors.
Installation Manuals Series 6 EV Charging Station - 1
Copyright ©2021 SemaConnect, Inc. All rights reserved. Page 15 of 25
To Next Page
Loading...
