Sena 10s - Sena 10 S Remote Control; Pairing with the Handlebar Remote; Using the Handlebar Remote

10S
45
English
15 REMOTE CONTROL
You can remotely control the 10S via Bluetooth using the Handlebar
Remote (sold separately). This eliminates the need to take off your
hand for button operations. Your 10S and the Handlebar Remote must
be paired together before use.
15.1 Pairing with the Handlebar Remote
1. Turn on the 10S and the Handlebar Remote.
2. Press the Jog Dial for 12 seconds to enter the conguration
menu. Rotate the Jog Dial until you hear a voice prompt saying,
“Remote control pairing”. Press the Phone Button to enter into
Remote Control Pairing mode and the red LED will ash rapidly
and you will hear multiple beeps. Please refer to
section 14.11,
“Remote Control Pairing”
for more details.
3. On the Handlebar Remote, press the Rear Button for 5 seconds
until its LED ashes red and blue. The 10S will automatically
perform pairing with the Handlebar Remote in pairing mode. You
will hear a voice prompt, “Remote control connected”, when
they are successfully connected.
15.2 Using the Handlebar Remote
Handlebar Remote button operations on various functions are
described in the table below.
Type Function Handlebar Remote LED
Basic
Function
Volume adjustment Move the Joystick up or down -
Conguration
menu
Press the Front Button for 10 seconds -
Mobile
Phone
Mobile phone
pairing
Press the Joystick for 5 seconds
Blue & red
alternatively
ashing
Second mobile
phone pairing
Press the Front Button for 5 seconds Red ashing
Tap the Rear Button within 2 seconds
Answer/End
phone call
Tap the Rear Button -
Voice dial Tap the Rear Button -
Speed dial Double tap the Rear Button -
Reject incoming
call
Press the Front Button for 2 seconds -