Sena 50R - Installing the Headset on Your Helmet; Installing the Main Unit

50R Low Profile Motorcycle Bluetooth
®
Communication System with Mesh Intercom™ | 9
2. INSTALLING THE HEADSET ON YOUR
HELMET
2.1 Installing the Main Unit
2.1.1 Using the Hook and Loop Fasteners for Main Unit
1. Clean the area on the left side of the helmet where you will attach the
hook and loop fasteners for main unit with a moistened towel and dry
thoroughly.
2. Peel off the cover of the adhesive tape of the loop fastener for main
unit and attach it to the helmet.
3. Peel off the cover of the adhesive tape of the hook fastener for main
unit and attach it to the back plate of the main unit.
4. Attach the main unit using the hook and loop fasteners that you
fitted. Make sure that the main unit is firmly attached to the helmet.
CHAPTER