SF Series
18
5.4.2 Using the Button
1. Turn on the two headsets (A and B) that you would like to pair with
each other.
2. Press and hold the Center Button for 5 seconds, then you will hear
a mid-toned single beep and a voice prompt, “Intercom pairing.”
3. Simply tap the Center Button of any one of the two headsets
A or B and wait until the intercom connection is automatically
established. The two headsets A and B are paired with each other
for intercom conversation. If the pairing process is not completed
within one minute, the headset will return to stand-by mode.
6 MOBILE PHONE, GPS, SR10
6.1 Mobile Phone Call Making and Answering
1. When you have an incoming call, tap the Center Button to answer
the call.
2. You can also answer the incoming call by loudly speaking any
word of your choice if
Voice Activated Phone Answering
(VOX
Phone) is enabled, unless you are connected to intercom.
3. To end a call, press the Center Button for 2 seconds until you
hear a mid-tone single beep, or wait for the called person to end
the call.
4. To reject a call, press the Center Button for 2 seconds until you
hear a beep while the phone is ringing.
5. There are several ways to make a phone call:
– Enter numbers on your mobile phone’s keypad and make a call.
Then the call is automatically transferred to the headset.
– In stand-by mode, press the Center Button for 3 seconds, to
activate the voice dialing of your mobile phone. For this, the
voice dialing function must be available on the mobile phone.
Refer to
your mobile phone manual
for further instruction.
To Next Page
