Sena SF1-01 - Installing the Speakers

SF Series
10
6. Peel off the glued cover and attach the main unit on the left side
of your helmet.
3.2 Installing the Speakers
1. Peel off each cover of the hook and loop fasteners for the speakers
to expose the adhesive surface.
2. Attach the fasteners to the ear pockets inside the helmet, and
then attach the speakers to the fasteners.
1
2
3. Connect the speaker cable to the speaker connector.
3.3 Installing the Microphones
3.3.1 Using the Wired Boom Microphone
1. Peel off the cover of the hook and loop fastener for the wired
boom microphone to expose the adhesive tape.
2. Attach the hook and loop fastener on the inside surface of the
left external shell, and then attach the wired boom microphone’s
mounting plate to the hook and loop fastener.
1
2