SF Series
9
English
4. Push and hold the clamp kit’s tab upwards. While pushing up the
tab, insert the main unit into the clamp kit.
1
2
5. Clean the area on the left side of the helmet where you will attach
the glued surface mounting adapter with a moistened towel and
dry thoroughly.
2. While pushing the latch at the center of the clamp kit, push the
back plate of the clamp kit outwards to remove it.
1
2
3. Align the glued surface mounting adapter and the back of the
clamp kit and slide the adapter into the clamp kit until you hear a
click. Make sure that the glued surface mounting adapter ts the
back of the clamp kit’s grooves.
To Next Page
Loading...
