Sena SF2 - Sena SF Series Headset Configuration; Voice Menu Navigation

SF Series
41
English
14 HEADSET CONFIGURATION SETTINGS
You can set the conguration of the SF Series by the voice menu
instruction described below.
1. To enter into voice conguration menu, press and hold the Center
Button for 10 seconds until you hear high-toned double beeps.
You will also hear a voice prompt, “Conguration menu”.
2. Tap the (+) Button or the (-) Button to navigate between the
menus. You will hear voice prompts for each menu item as below.
3. You can enable/disable a feature or execute a command by
tapping the Center Button.
4. If no button is pressed within 10 seconds, the SF Series will exit
the conguration and go back to stand-by mode.
5. If you want to exit the conguration immediately, tap the (+)
Button or the (-) Button until you hear a voice prompt, “Exit
conguration”, and tap the Center Button.
The voice prompt for each menu item is as below:
(1) Phone pairing (6) Delete all pairings
(2) Second mobile phone pairing (7) Remote control pairing
(3) GPS pairing (8) Universal intercom pairing
(4) Phone selective pairing (9) Factory reset
(5) Media selective pairing (10) Exit conguration
Phonepairing
Secondmobilephonepairing
GPSpairing
Phoneselectivepairing
Mediaselectivepairing
Deleteallpairings
Remotecontrolpairing
Universalintercompairing
Factoryreset
Exitconfiguration