To Next PageTo Next Page
Need help?Do you have a question about the Senco RoofPro 450 and is the answer not in the manual?
General| Type | Coil Roofing Nailer |
|---|---|
| Operating Pressure | 70-120 psi |
| Magazine Capacity | 120 |
| Fastener Type | Coil Roofing Nails |
| Power Type | Pneumatic |
| Fastener Range | 3/4" - 1-3/4" (19 - 44 mm) |
| Firing Mode | Contact or Sequential |
| Height | 10.5 inches |
| Width | 4.5" |
Assures manual is read and understood by personnel using the tool.
Emphasizes reading safety instructions before operating the tool.
Details on adjusting the magazine and loading the nail coil.
Describes operation modes for sequential and contact actuation triggers.
Instructions on how to adjust the fastener driving depth.
Steps for adjusting the shingle guide for proper nail placement.
Instructions on keeping screws tight and performing daily inspections.
Guidance on when and how to lubricate the tool with pneumatic oil.
Identifies symptoms and solutions for air leaks and slow operation.
Solutions for problems with the driver and nail feed jamming.
Details on nail collations, codes, lengths, and wire types for the SCN45.
Technical data including operating pressure, air consumption, weight, and dimensions.
Provides LpA and LwA sound levels for various models according to EN 792-13.
Lists vibration values (m/s²) for different models according to EN 792-13.
Lists available accessories for SENCO tools, including compressors, hoses, and safety gear.
States conformity with standards and directives for the product.
