Sencore SMD 989 - Page 97

SMD 989– User Manual
Page 97 (105)
IP TS Input –
Connector: (1) – 10/100/1000 Auto-negotiating Base-T
RJ-45 Ethernet Port
Input format: UDP, RTP, and RTP with extension headers
Multicast and Unicast
Bitrate Range: 0.5 – 160 Mbps
Packets/IP Frame 1-7 MPEG Packets/IP Frame
IGMP Compatibility: Version 2 and 3
Min TS Rate Supported: 0.5 Mbps
Max TS Rate Supported: 160 Mbps
Network Jitter Buffer: 100 KB to 4MB
IF-band Output –
Connector: (1) BNC, female
Impedance: 75 ohms
Min Level: -30 dBm
Max Level: -5 dBm
Level Adjustability: 1 dB increments
Frequency: 70 MHz Default (Selectable 57-145 MHz)
Frequency Stability: +/-5x10
-8
over operational temp range
Return Loss: >20 dB
Tilt Adjustment: +/- 3.0 dB in 0.1 dB steps
SMD 912 or SMD912A Single Stream Modulators
General –
RoHS Compliant: Yes
ASI Serial TS Input –
Connector: (2) BNC, female
Impedance: 75 ohms
Standard: ETSI EN 50083-9 DVB ASI
Data Bit Rate: 270 Mbps
Packet Size: 188 or 204 byte support
Transmission Mode: Burst and packet mode support
Min TS Rate Supported: .5 Mbps
Max TS Rate Supported: 213 Mbps
IP TS Input –
Connector: (2) – 10/100/1000 Auto-negotiating Base-T
RJ-45 Ethernet Ports
Input format: UDP, RTP, and RTP with extension headers
Multicast and Unicast
Bitrate Range: 0.5 – 213 Mbps
Packets/IP Frame 1-7 MPEG Packets/IP Frame
IGMP Compatibility: Version 2 and 3
Min TS Rate Supported: 0.5 Mbps
Max TS Rate Supported: 213 Mbps per stream
Network Jitter Buffer: 1 KB to 4MB
Buffer Size: 1-4000 KB, or 1-4000ms delay, user configured
Analysis: Duplicate, Lost, Corrected, Un-corrected, Out-of-
order packet counters
FEC Status: Row/Column Mode, Rows, Columns
Specifications are subject to change without notice.