Sencotel 153 - 4. Operation; 4.1 Filling

Prepare product Open refrigerator door
Fill the tank Reinstall the tank
and replace the lid
Remove level sensor
and suction tube
([WUDFW WKH WDQN
DQG ZLWKGUDZ WKH
lid
Close the refrigerator door
DQGVZLWFKRQWKHPDFKLQH
Be careful not to
damage the level
sensor when remov-
ing the lid from the
tank.
1 2
5 6
3 4
7 8
Prepare the product in a con-
tainer according to the man-
ufacturer’s instructions. The
refrigerator does not reduce
the temperature of the prod-
uct, it only maintains that
temperature. 'RQRWȴOOZLWK
KRWOLTXLGV3XWLQOLTXLGVDW
DWHPSHUDWXUHRI|&
2SHQ WKH GRRU XV-
ing the control lever
located on the lower
part of the door.
'LVFRQQHFW WKH OHYHO
sensor and the suc-
tion tube by pulling
upwards.
Pour the product
into the tank, adding
D PD[LPXP RI ȴYH
liters of the product.
Check that the lid is
FRUUHFWO\ȴWWHG
Connect the level sensor
and suction tube
The level of the mixture is
detected by the sensors
installed in the tank so,
ZKHQ LW LV EHLQJ ȴOOHG LW
is necessary to verify that
the connector is correct-
ly connected to the level
sensor.
Verify that the door is
correctly closed.
Press the general
switch located in the
lower front part of the
machine.
13
2SHUDWLRQ
3.1 Filling
Filling