Sennheiser Set 860 - Page 37

Using additional functions
Set 860 | 37
b Save the setting by disconnecting the transmitter from the
power supply system (see page 35).
Settings protection function
The settings protection function prevents accidental adjust-
ment of the hearing profile and the balance setting (this pro-
tection function is saved on the stethoset receiver). Switching
between stereo and mono operation on the transmitter is no
longer possible (this protection function is saved on the
trans-
mitter).
b Make sure that your stethoset receiver’s balance setting
and hearing profile are correctly adjusted (see page 23 and
24) and that the transmitter is set to stereo or mono opera-
tion as desired (see page 34).
b Make sure that the protected settings mode is activated
(see page 35).
b Place the stethoset receiver into the transmitter’s charging
compartment.
b Press the volume button + on the stethoset receiver to acti-
vate the settings protection function.
* factory default setting
b Save the setting by disconnecting the transmitter from the
power supply system (see page 35).
Status and display of
the settings
protection function
Function/behavior
activated
2
nd
LED segment lit
The activated hearing profile and the
balance setting for the stethoset
receiver cannot be changed/deacti-
vated. Switching between stereo and
mono operation on the transmitter is
not possible.
deactivated*
2
nd
LED segment off
The hearing profiles can be changed
at any time (see page 24), the
balance setting can be changed (see
page 23) and you can switch
between stereo and mono operation
(see page 34).