Sennheiser Set 880 - Page 8

Product overview
8 | Set 880
Overview of the Transmitter status LED
Overview of the acoustic signals/beeps
Transmitter status LED The transmitter...
– ... is in standby mode.
lights up white
... and the stethoset receiver are
connected. The speech
intelligibility function is
deactivated (see page 28).
lights up blue
... and the stethoset receiver are
connected. The speech
intelligibility function is activated
(see page 28).
flashes blue and white
... has detected an incompatible
digital audio signal (see page 11).
The LEDs on the transmitter indicate the current operating
state. If you are not pressing any button on the stethoset
receiver or the transmitter, the LEDs automatically dim
after approx. 30 seconds to not disturb you.
Beeps Meaning
during operation,
2 beeps
The rechargeable battery is almost
empty, recharge the rechargeable
battery (see page 15).
during operation, no
audio transmission,
5 beeps
The receiver is outside the trans-
mission range (see page 45).
when changing the
volume
The maximum or minimum volume
is reached (see page 23).
when changing the
balance setting
The maximum or minimum balance
setting is reached (see page 24).