SENSECAP S2120 - Page 12

To Next Page

To Previous Page

IoT into the Wild

Step 3: Place and lock the battery box door.

Step 4: Unscrew the battery door at bottom the of weather station.

Main Page

Table of Contents2
Product Introduction5
Introduction5
Quick Start Guide5
Part List6
Key Parameters of the Sensor7
Pre-Installation8
Diagram8
Install the Wind Sensor8
Install the Rain Gauge9
Power Supply Plan9
Install the Battery with Built-In Box10
Install the Battery with External Box11
LED of Sensor Working Status14
Sensecap Mate App16
Download App16
How to Connect Sensor to App17
Create a New Account17
Connect to Sensor to App18
Configure Parameters through App20
Select the Platform and Frequency20
Set the Interval23
Set the EUI and Key24
Set the Packet Policy24
Set the Activation Type25
Restore Factory Setting26
Connect to the Sensecap Portal27
Sensecap Portal27
Create a New Account27
Other Functions28
API Instruction28
Connect to Sensecap with Helium Network29
Quick Start29
Preparation29
Bind Sensor to Sensecap Portal30
Setup the Sensor32
Set Frequency of Sensor Via Sensecap Mate App33
Check Data on Sensecap Portal34
Connect to Sensecap with Private TTN35
Quick Start35
Preparation35
Bind Sensor to Sensecap Portal36
Setup the Sensor36
Set Frequency of Sensor Via Sensecap Mate App36
Check Data on Sensecap Portal37
Connect to Helium Network38
Connect to the Things Network38
Payload Decoder39
Decoder Code39
Packet Parsing40
Data Parsing Example41
Measurement Data Packets41
Battery Information Packets42
Lorawan Downlink Command44
Set the Data Uplink Interval44
Reboot the Device45
How to Send Downlink46
Device Installation47
Select an Appropriate Installation Location47
Installing the Weather Station47
Adjust the Solar Panel47
Install the Mounting Pole49
Direction Alignment51
Recommendation for Best Wireless Communication52

SENSECAP S2120 - Page 12

Table of Contents

Related product manuals