1. Wing release: Press to detach the wing.
2. Status LED/Pitot probe: The pitot probe is the sensor used by the eBee X
to calculate airspeed, wind and altitude. It must be kept clean and clear
of obstructions to function properly. A coloured LED, housed underneath,
lights up the entire semi-transparent probe in different colours, indicating
the drone’s status.
3. Battery compartment: The eBee X is powered by a LiHV (High Voltage
Lithium Polymer) battery stored within the battery compartment.
Caution: Safe charging and proper care of your battery are essen-
tial. Please read Battery care and safety on page 85 before using your
drone for the first time.
4. Camera compartment: The eBee X features a built-in camera for taking
aerial images stored within the camera compartment.
5. Central body: This is the core of the eBee X and includes all the electronics,
actuators and communications hardware on-board the drone.
6. Servo connection mechanism: The ailerons are connected to the servo-
motors within the central body of the drone through this connection mech-
anism.
7. Wing: The eBee X’s wings are detachable for storage and replacement. Each
wing has two wing struts and a clip to hold it in place within the central
body.
8. Winglet: Contributes to the aerodynamic efficiency of the wing.
9. Strobe light: Indicates the drone’s position in low-light conditions.
10. Propeller: Used to generate thrust while the drone is in flight.
To Next Page
Loading...
