Motor Head Unit InstallationMotor Head Unit Installation
LISH
E
N
G
22
Tightening the motor unit on a door with side plates
(KRAZI-DOOR, etc..)
For KRAZI DOOR (and other similar doors) it is
necessary to fabricate a steel baseplate and use
it in conjunction with the supplied u-bolt. This
configuration is the only acceptable one - not
doing this exactly as shown will lead to product
failure which is not covered by warranty!
Using steel bar, as indicated in "Required Tools and Equipment",
fabricate a steel baseplate with the following dimensions:
70mm
97mm
25mm
48.5mm
12.5mm
DIA TO SUIT TEK SCREW USED
DIA = 10mm
PLATE THICKNESS = 5~7mm
Notes:
Ensure all holes are drilled correctly- if they are too small it will be difficult to install
the u-bolt assembly with this baseplate.
Use of material thinner than 5mm is not recommended as it will distort and fatigue
due to the forces the door exerts on this part.
To Next Page
Loading...