24
Screw Lock
1. Thread the end of the rope through the hole furthest from the drum ange and
pull about 1 metre through (enough for 3 turns on the drum).
2. Wind the free end 3 turns on to the drum toward the ange by hand as tightly
as possible.
3. Pass the free end through the hole nearest to the ange and make sure it goes
right to the end of the hole.
4. Secure the end of the rope in this hole by tightening the locking screw.
5. Now wind the rope carefully on the drum while maintaining a pull on the rope
itself. Make certain that the rope ends wind up close together.
Wind the rope on the drum to exit either above or below as required.
To Next Page
Loading...
