87
8.2 Design standard
Sepson’s VEHICLE RECOVERY WINCHES are designed according to the
following standards
Directive 2006/42/EC Machinery
(Harmonised C-standard)
EN 14492-1:2006 + A1:2009 Cranes – Power driven winches and hoists
Part 1: Power driven winches
(Supporting safety standards)
EN ISO 12100:2010 Safety of machinery – General principles for
design. - Risk assessment and risk reduction
EN ISO 4413:2010 Hydraulic
EN ISO 4414:2010 Pneumatics
EN 60204-1:2006 Electrical equipment of machines
Part 1: general requirement
DIN 15020-1 Strength of gear transmissions
EN 60529/A1:2013 Degrees of protection provided by enclosures
(IP code)
EN 13732-1:2008 Methods for the assessment of human
responses to contact with surfaces
Part 1: Hot surfaces
EN 13857:2008 Safety distances to prevent hazard zones
being reach by upper and lower limbs
Directive 92/58/EEC Safety and health signs at work
IAW SAE J706 US Standard (applies only to some winches)
Technical information
To Next Page
Loading...
