42
Position Part Explanation
1 Winch with
hydraulics
1.1 Hydraulic block Double overcentre valve, shuttle valve and
pressure gauge outlet mounted direct on to
one of the motors. The ports marked V1 and
V2 are for the hydraulic connections from the
control valve on the vehicle´s hydraulic
system. They both have R 1/2” or 3/4” thread.
1.1.2 Double overcentre
valve
This allows the load to be spooled out at a
controlled rate. It also provides burst hose pro-
tection. It is adjusted and sealed in our factory.
1.1.3 Shuttle valve Supplies pressure for the spring loaded.
1.1.4 Pressure gauge
outlet
R 1/4” female threaded connection. (Not on all
winch models).
To Next Page
Loading...
