Server Technology switched pro2 - Page 165

Switched PRO2 – User Guide
Using the Command Line Interface (CLI) • 165
set net
Sets network mode configuration values.
Command Syntax
set net [disabled | ipv4only | dualv6v4]
Parameters
The set net command uses the following parameters:
disabled
Disables network access to system.
ipv4only
System only allows IPv4 functionality.
Dualv6v4
System allows IPv6 and IPv4 functionality.
Command Access
Admin level only; no access in Demo mode.
set ocp
Sets over-current protector (OCP) configuration values.
Command Syntax
set ocp email [disabled | enabled] <name | id | ALL>
set ocp loadmax <name | id | ALL> <value>
set ocp snmpt [disabled | enabled] <name | id | ALL>
Parameters
The set ocp command uses the following parameters:
email
Email notifications for OCP events.
loadmax
Maximum current load for an OCP. Valid range is 1 to “max factory
current” from the show ocps command.
snmpt
SNMP trap notifications for OCP events.
Command Access
Admin level only