7
Startup
Parameterization of the drive safety functions
Manual – MOVISAFE
®
CSB51A Safety Option
24
6. Parameterization
Set the parameterization according to your safety-related requirements of your ap-
plication.
For parameterization of the MOVISAFE
®
CSB51A safety option, call the individual
sections in the parameter tree and enter the required values. The higher-level pa-
rameters such as start inhibit after power on, muting, maximum muting time and
enable emergency mode can be set in the "Basic settings" area. The correspond-
ing F-protocol is set in the section "Communication". After this, the parameters of
the drive safety functions STO and SS1(c) are set.
The "AssistCS.." parameterization tool creates a new parameter set from all of the
parameters.
7. Transferring the parameter set to the device
Click the [Download] button to transfer the parameter set to the
MOVISAFE
®
CSB51A safety option.
After the download, the transferred parameter set is checked for consistency and
plausibility. Possibly existing inconsistencies or plausibility errors are displayed
and can then be corrected.
For a detailed description of steps 4–7, refer to chapter "Assist CS..".
Once the parameter set has been transferred to the MOVISAFE
®
CSB51A safety op-
tion without any errors, you can start up the standard functions and make the connec-
tion to the higher-level safety controller (F-PLC).
25931075/EN – 04/2019
To Next Page
Loading...
Need help?
General
