Sewha SI 410 - Page 29

- 29 -
216
Port 2 Modbus communication
data SWAP
00
00 : Basic
01 : Customizing
250
Ethernet Communication mode
00
00: Simplex / Stream Mode
01: Duplex / Command Mode
02: Duplex / Command Mode (Compatible with
SI4100)
04: Modbus(RTU)
251
Ethernet Format under Stream
Mode
00
00 : Format 1 (18byte)
01 : Format 2 (21byte)
02 : Format 3 (17byte)
03 : Format 4 (22byte)
04 : Format 5 (15byte)
252
Ethernet transference under
stream mode
00
00 : Countinuously
01 : Single time on every steady state
02 : Single time at the first steady point
03 : Single time output after weighing finish
04 : When input Print key
253
Ethernet “Check-Sum” under
command mode
00
00 : Disuse
01 : Use
254
Ethernet Modbus LCB/MSB
setting
00
00 : Disuse
01 : Use
Remark: If BCD-OUT option is needed, F250 must set as 00
F-list
Subject
Def
Option
300
Analog Output Direction
00
00 : Forward
01 : Reverse
301
Analog Output Applying
Weight Range
00
00 : Absolute number(-&+)
01 : Positive number(only +)
302
Analog Output Standard
02
00 : Within 10% of Max Capacity
01 : Within 20% of Max Capacity
02 : Within 50% of Max Capacity
03 : Within 100% of Max Capacity
310
BCD IN Enter method
(Part Number)
00
00 : Disuse
01 : Enter the Unit digit, and Tenth digit with
dividing
02 : Enter the Unit digit, and Tenth digit
without dividing
03 : Absolute value