Sewha SI 410 - Maximum Analog Output Setting; Factory Reset; Ip Address Check; Modification; GateWay Check; Modification

- 40 -
Maximum Analog Output Setting
HF11
Maximum Analog Output (Analog out 4~20mA / 0~10V).
The 4-20Ma’s begin number is “0”, so after enter the Function mode and write the “-4” to
show “20mA”
key press (–) Setting. Input range : -20 ~ +20 , basic value : 0
Input 0mV of the Simulating Calibration input value
HF12
When input simulating calibration value, it is able to set 0mV.
Input 2mV of the Simulating Calibration input value
HF13
When input simulating calibration value, it is able to set 2mV.
Function List Factory Reset
HF14
Change to default F-Setting
Factory Reset
HF15
Change to default all of Setting
Ip Address Check / Modification
HF16
Check or adjust the IP Address
Ip Address Check / Modification
HF17
Check or adjust the IP Address
Ip Address Check / Modification
HF18
Check or adjust the IP Address
Ip Address Check / Modification
HF19
Check or adjust the IP Address
GateWay Check / Modification
HF20
Check or adjust the GateWay
GateWay Check / Modification
HF21
Check or adjust the GateWay
GateWay Check / Modification
HF22
Check or adjust the GateWay
GateWay Check / Modification
HF23
Check or adjust the GateWay
SubNet Mask Check / Modification
HF24
Check or adjust the SubNet Mask
SubNet Mask Check / Modification
HF25
Check or adjust the SubNet Mask
SubNet Mask Check / Modification
HF26
Check or adjust the SubNet Mask