Sewha SI 410 - Page 8

- 8 -
3-3-3. Key Operation
- Press 4 times within 3secs, to enter to Function setting mode.
- Press 4 times within 3secs, to enter to “Hidden function” mode.
- Make the weight value to Zero (It doesn’t work under hold state or weight is near
zero.)
- Enter to function mode in SET-UP mode.
- Number 1
- Set the TARE Function
1st input : “TARE”, 2nd input : “TARE Reset”
(When “HOLD” or weight value is ZERO, then this key doesn’t work.)
- Number 2
- Set the “HOLD” Function
1st input : “HOLD”, 2nd input : “HOLD Reset”
- Number 3
- Product number setting
- Number 4
- Print out
- Number 5
- Make Run or stop weight mode
- Number 6
- SP1 set value setting
- Number 7
- SP2 set value setting
- Number 8
- SP3 set value setting
- Number 9
- SP4 set value setting
- Number 0
- Cancel or Move to previous step
- Save and Move to next step