ESC FF
[Name] Print data in page mode
[Format] ASCII ESC FF
Hex 1B 0C
Decimal 27 12
[Description] In page mode, prints all buffered data in the printable area collectively.
[Details] ·This command is enabled only in page mode.
·After printing, the printer does not clear the buffered data, setting value
for ESC T and ESC W, and the position for buffering character data.
[Reference] FF, ESC L, ESC S
ESC SP
n
[Name] Set right-side character spacing
[Format] ASCII ESC SP
n
Hex 1B 20
n
Decimal 27 32
n
[Range] 0≤
n
≤ 255
[Description] Sets the character spacing for the right side of the character to
[
n
x horizontal or vertical motion units].
[Details] ·The right-side character spacing for double-width mode is twice the
normal value. When characters are enlarged, the right-side character
spacing is
n
times normal value.
·This command does not affect the setting of Kanji characters.
·This command sets values independently in each mode (standard and
page modes).
·The horizontal and vertical motion units are specified by GS P.
Changing the horizontal or vertical motion units does not affect the
current right-side spacing.
TITLE : WTP-150
Page -27 -
To Next Page
Loading...
