SEWOO WTP-150 - Page 29

·The GS P command can change the horizontal (and vertical) motion unit.
However, the value cannot be less than the minimum horizontal
movement amount, and it must be in even units of the minimum
horizontal movement amount.
·In standard mode, the horizontal motion unit is used.
·In page mode, the horizontal or vertical motion unit differs in page mode,
depending on starting position of the printable area as follows:
①When the starting position is set to the upper left or lower right of the
printable area using ESC T, the horizontal motion unit (x) is used.
②When the starting position is set to the upper right or lower left of the
printable area using ESC T, the vertical motion unit (y) is used.
·The maximum right-side spacing is 35.983 mm {255/180” }. Any setting
exceeding the maximum is converted to the maximum automatically.
[Default]
n = 0
[Reference] GS P
ESC ! n
[Name] Select print mode(s)
[Format] ASCII ESC !
n
Hex 1B 21
n
Decimal 27 33
n
[Range]
0≤ n ≤ 255
[Description] Selects print mode(s) using
n as follows:
Bit Off/On Hex Decimal Function
Off 00 0 Character font A (12x24) 0
On 01 1 Character font B (9x24)
1 - - - Undefined.
2 - - - Undefined.
Off 00 0 Emphasized mode not selected. 3
On 08 8 Emphasized mode selected.
Off 00 0 Double-height mode not selected. 4
On 10 16 Double-height mode selected.
Off 00 0 Double-width mode not selected. 5
On 20 32 Double-width mode selected.
6 - - - Undefined.
Off 00 0 Underline mode not selected. 7
On 80 128 Underline mode selected.
TITLE : WTP-150
Page -28 -