Shark HD510 CNC Setup and Execution
When operating machinery always wear the appropriate ear and eye protection and follow all safety instructions.
The Shark HD510 CNC should never be left unattended while it is operating. It is important that you monitor the
machine while it is running and be prepared to stop it if the situation arises.
These startup instructions have been developed using the Shark HD510 Users Guide and the Ready 2 Control User Guide.
Listed below are the primary procedures you will need to follow when using the CNC machine.
Generating G-Code Using VCarve Pro Makerspace Version 11.0xx or 11.55 ..................................................................... 2
Shark HD510 CNC Power Up Sequence .............................................................................................................................. 4
Moving The Gantry ............................................................................................................................................................. 7
Securing Your Project .......................................................................................................................................................... 8
Loading the Tool.................................................................................................................................................................. 9
Setting the X and Y Axis to Zero ........................................................................................................................................ 10
Setting the Z Axis to Zero .................................................................................................................................................. 11
Load and Check G-Code .................................................................................................................................................... 12
Running the Project .......................................................................................................................................................... 13
Power Down Sequence ..................................................................................................................................................... 15
To Next Page
Need help?
General
